Mooring Rope Retainers (3D printing)
I like to keep all my mooring ropes handy but I'm paranoid about them falling overboard so I always tended to tie them to the handrails before dropping them inside the cockpit. Unfortunately, this means they're not as handy as they could be, so I designed these for my Fairline Targa 27:-







They can also be used as coat hangars; their low height prevents them snagging on your clothes.

Unfortunately there isn't an obvious place to put these on my current boat so I am experimenting with designs for retainers that snap onto the side rails. I'm not entirely happy with the ones I've currently made but will update this site when I finalise the design.